Crusher machine use precautions
1, plastic crusher and power unit to install firmly. If the plastic crusher needs long-term fixed operation, it should be fixed on the cement basis; If the plastic crusher flow operation is required, the unit should be installed on the frame made of Angle iron, and ensure that the power engine (diesel engine or electric motor) and the plastic crusher pulley groove are in the same plane of rotation.
2, check the fastening of all parts of the fasteners after installation, if loose to be given to tighten. At the same time, check whether the tightness of the belt is appropriate.
3, before starting, first rotate the rotor by hand, check whether the jaw, hammer and rotor operation is flexible and reliable, there is no collision in the crushing room, whether the rotation direction of the rotor is consistent with the direction pointed by the arrow of the machine, whether the lubrication of the power machine and the plastic crusher is good.
4, do not casually replace the pulley, to prevent the speed is too high resulting in an explosion in the crushing chamber, or the speed is too low affecting the working efficiency of the crusher.
5, the plastic crusher should be kept idling for 2 to 3 minutes after starting, no abnormal phenomenon and then feeding work.
6, the work should always pay attention to the operation of the plastic crusher, first of all, the feeding should be uniform, to prevent blocking the crushing chamber; Second, don’t overwork for a long time. If it is found that there are vibration, noise, bearing and body temperature is too high, spraying material, etc., it should be stopped immediately for inspection, and the fault can be removed before continuing to work.
